README (Thermosalinograph : MR06-05 Leg1 and Leg2) 1. Preface ---------- Thermosalinograph measures the following surface parameters continuously. - temperature - salinity - dissolved oxygen Sea surface water is continuously pumped up at 4.5 meters depth to the sea surface monitoring laboratory and then flowed into each analysis equipment through a steel pipe and a vinyl-chloride pipe. The flow rate of this system is controlled by some valves. 2. Sensor specifications ------------------------ (1) Temperature sensor Model : SBE 3S, Sea-Bird Electronics,Inc. Serial number : 032607 Measurement range : -5 to 35 deg-C (ITS-90) Sensor location : Bow thruster room (2) Salinity sensor SEACAT THERMOSALINOGRAPH Model : SBE-21, Sea-Bird Electronics,Inc. Serial number : 2126391-3126 Measurement range : (temperature) -5 to +35 deg-C (ITS-90) (conductivity) 0 to 6.5 S/m Sensor location : Sea surface monitoring laboratory (3) DO sensor Model : 2127A, Hach Ultra Analytics Japan Inc. Serial number : 44733 Measurement range : 0 to 14 ppm Sensor location : Sea surface monitoring laboratory 3. Data acquisition ------------------- --------------------------------------------------------------------------- Date,Time(UTC) Start/Stop Locations (YYYY/MM/DD,hh:mm:ss) --------------------------------------------------------------------------- 2006/10/04,11:46 start 39-46.73N,142-20.49E 2006/10/11,01:59 stop 17-14.44N,117-03.65E 2006/10/12,19:06 start 10-10.43N,110-55.72E 2006/10/13,19:28 stop 06-33.82N,107-49.89E 2006/10/16,20:13 start 03-20.35N,100-26.59E 2006/10/17,09:16 stop 06-05.26N,098-27.66E 2006/10/18,19:02 start 01-59.97N,092-13.78E 2006/10/23,11:09 stop 02-40.27N,079-43.93E 2006/10/23,14:15 start 02-41.61N,079-38.37E 2006/10/29,18:57 stop 00-00.07S,080-28.65E 2006/10/29,19:04 start 00-00.11S,080-28.68E 2006/11/26,01:53 stop 01-05.93N,077-26.58E 2006/11/28,23:01 start 02-47.57N,077-08.53E 2006/12/10,11:00 stop 03-15.66N,091-55.06E 2006/12/11,22:01 start 05-44.23N,098-38.88E 2006/12/12,10:00 stop 03-26.57N,100-20.37E --------------------------------------------------------------------------- 4. Data Format -------------- Each file contains the number of data lines at the first line. From the second line, the following parameters are stored. Date in UTC (YYYYMMDD HHMM) Latitude in degN/degS (**-**.**N/S) Longitude in degE (***-**.**E) Temperature in degC Salinity in PSU Dissolved Oxygen in mg/l Bad values are expressed as "-9.0". - end -