Schlumberger Verification Listing

Listing Created: 28-FEB-2019 14:33:42

  
Input Source: C0002T_Run1_DML_DLIS_Time.dlis
Format: DLIS
Storage Set ID: Default Storage Set

Max Record Length: 8192
Storage Unit Sequence: 1

  
File Header  File: C0002T_Run1_DML_DLIS_Time_(1) Sequence: 1  
  Defining Origin: 103
  File ID: C0002T_Run1_DML_DLIS_Time_(1) File Type: PRODUCER
  Producer Name: Schlumberger Product/Version: HZ-OP:DnM 8.2.104493.3100 File Set: 1056990976 File Number: 1 28-FEB-2019 13:57:56
     
          Company Name: JAMSTEC
          Well Name: C0002T
          Field Name: C0002
          Tool String: MWD_10
          Computations: LOCALCOMPUTATION, SURVEY
  
Well Site Data  File: C0002T_Run1_DML_DLIS_Time_(1) Sequence: 1  
  Origin: 103
    Well Data
  Company Name JAMSTEC CN
  Well Name C0002T WN
  Field Name C0002 FN
  Prefecture Wakayama SLAB, STAT
  Nation Japan NATI
  Continent Asia CONT
  Field Location Pacific Ocean FL
  X=652382.39m FL1
  Y=3685843.62m FL2
  Service Order Number 18JAP0007 SON
  Longitude 136° 38' 12.174" E LONG
  Latitude 33° 18' 3.042" N LATI
  Maximum Hole Deviation 5.000 (deg) MHD
  Elevation of Kelly Bushing 0.0 (m) EKB
  Elevation of Ground Level -1939.0 (m) EGL
  Elevation of Drill Floor 28.500 (m) EDF
  Permanent Datum MSL Elevation of Permanent Datum (PDAT) above Mean Sea Level    0.0 (m) PDAT, EPD
  Logging Measured From (Name of Logging Elevation Reference) DF Elevation of Depth Reference (LMF) Above Permanent Datum    28.500 (m) LMF, APD
  Drilling Measured From (Name of Drilling Elevation Reference) DF DMF

Absent Valued Parameters: CN1, COUN, SECT, TOWN, RANG, APIN

    Job Data
  Date of Operation 14-Feb-2019 DATE
  Run Number Run 1 RUN
  Driller Total Depth 4804.0 (m) TDD
  Logger Total Depth 4804.0 (m) TDL
  Bottom Log Interval 4804.0 (m) BLI
  Top Log Interval 4784.0 (m) TLI
  Current Casing Size 10.625 (in) CSIZ
  Casing Depth From 4603.5 (m) CDF
  Casing Depth To 4770.2 (m) CADT
  Casing Grade N/A CASG
  Casing Weight 24.964 (lbm/ft) CWEI
  Bit Size 8.500 (in) BS
  Bit Size Depth From 4780.0 (m) BSDF
  Bit Size Depth To 4804.0 (m) BSDT
  Begin Log Date 14-Feb-2019 Begin Log Time    21:47:33 DLAB, TLAB
  Logging Unit Number OLU-MB8054 Logging Unit Location    Zone2 LUN, LUL
  Engineer s Name YePu/Ikhsan Anugrah ENGI
  Witness s Name YSanada/YKido WITN
  Service Order Number 18JAP0007 SON
    Mud Data
  Drilling Fluid Type WATER DFT
  Drilling Fluid Density 1.360 (g/cm3) Drilling Fluid Viscosity    68.000 (s) DFD, DFV
  Drilling Fluid Loss 7.000 (cm3) Drilling Fluid pH    11.900 DFL, DFPH
  Fluid Interval Transit Time 206.00 (us/ft) FVEL
  Borehole Salinity 34972.2 (ppm) BSAL
  Mud Sample Source Active Tank MSS
  Resistivity of Mud Sample 0.200 (ohm.m) Mud Sample Temperature    20.000 (degC) RMS, MST
  Resistivity of Mud Filtrate Sample 0.150 (ohm.m) Mud Filtrate Sample Temperature    20.000 (degC) RMFS, MFST
  Resistivity of Mud Cake Sample -999.25 (ohm.m) Mudcake Sample Temperature    20.000 (degC) RMCS, MCST
  Resistivity of Mud at Bottom Hole Temperature 0.0684 (ohm.m) RMB
  Resistivity of Mud Filtrate At Bottom Hole Temperature 0.0513 (ohm.m) RMFB
  Maximum Recorded Temperature 37.840 (degC) MRT
  37.840 (degC) MRT1
  -999.25 (degC) MRT2
  -999.25 (degC) MRT3
  End Log Date 17-Feb-2019 End Log Time    11:14:07 DCS, TCS
  Begin Log Date 14-Feb-2019 Begin Log Time    21:47:33 DLAB, TLAB
    PVT Data
  Oil Density -999.25 (kg/m3) ODEN
  Borehole Salinity 34972.2 (ppm) BSAL
  Oil Formation Volume Factor, Bo -999.25 BO
  Water Formation Volume Factor, Bw -999.25 BW
  1/Gas Formation Volume Factor, 1/Bg -999.25 IBG
  Bubble Point Pressure -999.25 (MPa) BPP
  Bubble Point Temperature -999.25 (degC) BPT
  Solution Gas Oil Ratio -999.25 (m3/m3) SGOR
    Cement Data

Absent Valued Parameters: CASN

    Remarks
  Depth Reference is driller's depth measured from Rotary Table. R1
  Data presented is Recorded Mode data which was acquired while drilling. R2
  Reason of POOH: Client called well TD R8
  Drilling Time: 10.42 hrs R9
  Pumping Time: 20.65 hrs R10
  No DTOR reading because of the dpoint issue. R11
Channels  File: C0002T_Run1_DML_DLIS_Time_(1) Sequence: 1  
  Origin: 103
    MWD_10: TeleScope 675 IWOB

      Spacing: 1000.0 ms            Number of Channels: 9
AZIM_CONT_RT CRPM      DWOB_RT   HR_TRPM   INCL_CONT_RT NRPM      SHKR      SHKTOT    STUCK_LVL
    System and Miscellaneous

      Spacing: 1000.0 ms            Number of Channels: 9
BPOS      ETIM      HKLD      RPM       SPPA      SWOB      TFLO      TIME      TQA      
Frame Summary  File: C0002T_Run1_DML_DLIS_Time_(1) Sequence: 1  
Origin: 103
  Index Type Start Stop Spacing Channels Index Channel Frame Name
  TIME

0.00

221192.98 s

2000.0 (0.5 ms)

18

TIME   

2000T   

Error Summary  File: C0002T_Run1_DML_DLIS_Time_(1) Sequence: 1  
        No errors detected in file.
Schlumberger Verification Listing

Listing Completed: 28-FEB-2019 14:33:42